Reference Guide

IPv6 Access Control Lists (IPv6 ACLs) | 737
25
IPv6 Access Control Lists (IPv6 ACLs)
Overview
IPv6 ACLs and IPv6 Route Map commands are supported on Dell Force10
platforms, as indicated by the characters that appear under each of the
command headings:
e E-Series, c C-Series, s S-Series, , or
.
• IPv6 ACL Commands
• IPv6 Route Map Commands
Important Points to Remember
• E-Series platforms require IPv6-ExtACL CAM profile to support IPv6 ACLs.
• C-Series and S-Series platforms require manual CAM usage space allotment.
Refer to cam-acl later in this document.
• Egress IPv6 ACL and IPv6 ACL on Loopback interface is not supported.
• Reference to an empty ACL will permit any traffic.
• ACLs are not applied to self-originated traffic (e.g. Control Protocol traffic not
affected by IPv6 ACL since the routed bit is not set for Control Protocol traffic
and for egress ACLs the routed bit must be set).
• The same access list name can be used for both IPv4 and IPv6 ACLs.
• Both IPv4 and IPv6 ACLs can be applied on an interface at the same time.
• IPv6 ACLs can be applied on physical interfaces and a logical interfaces
(Port-channel/VLAN).
• Non-contiguous masks are not supported in source or destination addresses in
IPv6 ACL entries.
• Since prefix mask is specified in
/x format in IPv6 ACLs, inverse mask is not
supported.
Note: For IPv4 ACL commands, refer to IPv6 Access Control Lists (IPv6 ACLs).