Reference Guide

IPv6 Access Control Lists (IPv6 ACLs) | 739
Parameters
Command Modes
CONFIGURATION
Command
History
Usage
Information
You must save the new CAM settings to the startup-config (write-mem or copy
run start
) then reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires 3
blocks and these cannot be reallocated.
When configuring space for IPv6 ACLs, the total number of Blocks must
equal 13.
Ranges for the CAM profiles are 1-10, except for the
ipv6acl profile which is
0-10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
cam-acl-egress
c e s
Allocate space for IPv6 egress ACLs.
Syntax
cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4}
default
Use the default CAM profile settings, and set the CAM as
follows.
L3 ACL (ipv4acl): 6
L2 ACL(l2acl): 5
IPv6 L3 ACL (ipv6acl): 0
L3 QoS (ipv4qos): 1
L2 QoS (l2qos): 1
l2acl 1-10 ipv4acl 1-10 ipv6acl
0-10 ipv4qos 1-10 l2qos 1-10
Allocate space to support IPv6 ACLs. You must enter all of
the profiles and a range.
Enter the CAM profile name followed by the amount to be
allotted.
The total space allocated must equal 13.
The
ipv6acl range must be a factor of 2.
Version 8.3.19.0 Introduced on the S4820T
Version 8.3.7.0 Introduced on the S4810
Version 8.4.2.0 Introduced on the E-Series TeraScale
Version 8.2.1.0 Introduced on the S-Series
Version 7.8.1.0 Introduced on the C-Series