Reference Guide

740 | IPv6 Access Control Lists (IPv6 ACLs)
www.dell.com | support.dell.com
Parameters
Command Modes
CONFIGURATION
Command
History
Usage
Information
You must save the new CAM settings to the startup-config (write-mem or copy
run start
) then reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires 3
blocks and these cannot be reallocated.
When configuring space for IPv6 ACLs, the total number of blocks must equal
13.
Ranges for the CAM profiles are 1 to 10, except for the
ipv6acl profile which is
0-10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
Example
FTOS#
FTOS#configure
FTOS(conf)#cam-acl-egress ?
default Reset Egress CAM ACL entries to default setting
l2acl Set L2-ACL entries
FTOS(conf)#cam-acl-egress l2acl ?
<1-4> Number of FP blocks for l2acl
FTOS(conf)#cam-acl-egress l2acl 1 ?
ipv4acl Set IPV4-ACL entries
FTOS(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ?
ipv6acl Set IPV6-ACL entries
FTOS(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl ?
<0-4> Number of FP blocks for IPV6 (multiples of 2)
FTOS(conf)#cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl 2
clear counters ipv6 access-group
c e s
Erase all counters maintained for the IPv6 access lists.
default
Use the default CAM profile settings, and set the CAM as
follows.
L2 ACL(l2acl): 1
L3 ACL (ipv4acl): 1
IPv6 L3 ACL (ipv6acl): 2
l2acl 1-4 ipv4acl 1- 4 ipv6acl
0-4
Allocate space to support IPv6 ACLs. You must enter all of the
profiles and a range for each.
Enter the CAM profile name followed by the amount to be
allotted.
The total space allocated must equal 13.
The
ipv6acl range must be a factor of 2.
Version 8.3.19.0 Introduced on the S4820T
Version 8.3.7.0 Introduced on the S4810
Version 8.4.2.0 Introduced on the E-Series TeraScale
Version 8.2.1.0 Introduced on the S-Series
Version 7.8.1.0 Introduced on the C-Series