Reference Guide

IPv6 Access Control Lists (IPv6 ACLs) | 741
Syntax
clear counters ipv6 access-group [access-list-name]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
deny
c e s
Configure a filter that drops IPv6 packets that match the filter criteria.
Syntax
deny {ipv6-protocol-number | icmp | ipv6 | tcp | udp}
To remove this filter, you have two choices:
• Use the
no seq sequence-number command syntax if you know the filter’s
sequence number or
• Use the
no deny {ipv6-protocol-number | icmp | ipv6 | tcp | udp} command.
Parameters
Defaults
Not configured.
Command Modes
ACCESS-LIST
Command
History
access-list-name
(OPTIONAL) Enter the name of a configured access-list, up to 140
characters.
Version 8.4.2.1 Introduced on the S-Series
Version 8.2.1.0 Introduced on the E-Series ExaScale
Version 7.8.1.0 Introduced on the C-Series
Version 7.4.1.0 Introduced on the E-Series TeraScale
Added
monitor option
ip-protocol-number
Enter an IPv6 protocol number.
Range: 0 to 255
icmp
Enter the keyword icmp to deny Internet Control Message Protocol
version 6.
ipv6
Enter the keyword ipv6 to deny any Internet Protocol version 6.
tcp
Enter the keyword tcp to deny the Transmission Control protocol.
udp
Enter the keyword udp to deny the User Datagram Protocol.
Version 8.4.2.1 Introduced on the S-Series
Version 8.2.1.0 Introduced support on the E-Series ExaScale
Version 7.8.1.0 Introduced support on the C-Series
Version 7.4.1.0 Introduced support on the E-Series TeraScale