Reference Guide

748 | IPv6 Access Control Lists (IPv6 ACLs)
www.dell.com | support.dell.com
To delete an IPv6 access-group configuration, use the no ipv6 access-group
access-list-name {in} [implicit-permit] [vlan range] command.
Parameters
Defaults
Disabled
Command Modes
INTERFACE
Command
History
Usage
Information
You can assign an IPv6 access group to a physical, LAG, or VLAN interface
context.
Example
FTOS(conf-if-gi-9/0)#ipv6 access-group AclList1 in implicit-permit vlan 10-20
FTOS(conf-if-gi-9/0)#show config
!
interface GigabitEthernet 9/0
no ip address
ipv6 access-group AclList1 in implicit-permit Vlan 10-20
no shutdown
FTOS(conf-if-gi-9/0)#
ipv6 access-list
c e s
Configure an access list based on IPv6 addresses or protocols.
Syntax
ipv6 access-list access-list-name
To delete an access list, use the
no ipv6 access-list access-list-name command.
Parameters
Defaults
All access lists contain an implicit “deny any”; that is, if no match occurs, the
packet is dropped.
access-list-name
Enter the name of a configured access list, up to 140 characters.
in | out Enter either the keyword in or out to apply the IPv6 ACL to incoming
traffic (ingress) or outgoing traffic (egress).
implicit-permit
(OPTIONAL) Enter the keyword implicit-permit to change the default
action of the IPv6 ACL from implicit-deny to implicit-permit (that is, if
the traffic does not match the filters in the IPv6 ACL, the traffic is
permitted instead of dropped).
vlan range (OPTIONAL) Enter the keyword vlan followed by the VLAN range in a
comma separated format.
Range: 1 to 4094
Version 8.4.2.1 Introduced on the S-Series
Version 7.8.1.0 Introduced on the C-Series
Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are
up to 16 characters long.
Version 7.4.1.0 Introduced on the E-Series TeraScale
access-list-name Enter the as the access list name as a string, up to 140 characters.