Reference Guide

Control and Monitoring | 75
Example
FTOS#configure
FTOS(conf)#
debug cpu-traffic-stats
c e s
Enable the collection of CPU traffic statistics.
Syntax
debug cpu-traffic-stats
Defaults
Disabled
Command Modes
EXEC Privilege
Command
History
Usage
Information
This command enables (and disables) the collection of CPU traffic statistics from the
time this command is executed (not from system boot). However, excessive traffic
received by a CPU will automatically trigger (turn on) the collection of CPU traffic
statics. The following message is an indication that collection of CPU traffic is
automatically turned on. Use the show cpu-traffic-stats to view the traffic statistics.
Excessive traffic is received by CPU and traffic will be rate controlled
Related
Commands
debug ftpserver
c e s
View transactions during an FTP session when a user is logged into the FTP server.
Syntax
debug ftpserver
Command Modes
EXEC Privilege
Command
History
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced on E-Series
Note: This command must be enabled before the show cpu-traffic-stats command
will display traffic statistics
. Dell Force10 recommends that you disable debugging
(
no debug cpu-traffic-stats) once troubleshooting is complete.
show cpu-traffic-stats Display cpu traffic statistics
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series