Reference Guide

752 | IPv6 Access Control Lists (IPv6 ACLs)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
source address
Enter the IPv6 address of the network or host from which the packets
were sent in the
x:x:x:x::x format followed by the prefix length in the /x
format.
Range: /0 to /128
The
:: notation specifies successive hexadecimal fields of zero.
mask
Enter a network mask in /prefix format (/x).
any
Enter the keyword any to specify that all routes are subject to the filter.
host ipv6-address
Enter the keyword host followed by the IPv6 address of the host in the
x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zero
operator
(OPTIONAL) Enter one of the following logical operand:
•
eq = equal to
•
neq = not equal to
•
gt = greater than
•
lt = less than
•
range = inclusive range of ports (you must specify two port for the
port parameter.)
port port Enter the application layer port number. Enter two port numbers if
using the range logical operand.
Range: 0 to 65535.
The following list includes some common TCP port numbers:
23 = Telnet
20 and 21 = FTP
25 = SMTP
169 = SNMP
destination address
Enter the IPv6 address of the network or host to which the packets are
sent in the
x:x:x:x::x format followed by the prefix length in the /x
format.
Range: /0 to /128
The
:: notation specifies successive hexadecimal fields of zero.
bit Enter a flag or combination of bits:
ack: acknowledgement field
fin: finish (no more data from the user)
psh: push function
rst: reset the connection
syn: synchronize sequence numbers
urg: urgent field
count
(OPTIONAL) Enter the keyword count to count packets processed by
the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the
filter.
log
(OPTIONAL) Enter the keyword log to enter ACL matches in the log.
monitor
(OPTIONAL) Enter the keyword monitor to monitor traffic on the
monitoring interface specified in the flow-based monitoring session
along with the filter operation.