Reference Guide

78 | Control and Monitoring
www.dell.com | support.dell.com
enable optic-info-update interval
Enable polling intervals of optical information updates for SNMP.
Syntax
enable optical-info-update interval seconds
To disable optical power information updates, use the no enable optical-info-update
interval
command.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
The default interval for the polling is 300 seconds (5 minutes). Use this command to
enable the polling and to configure the polling frequency.
enable xfp-power-updates
c e s
Enable XFP power updates for SNMP.
Syntax
enable xfp-power-updates interval seconds
To disable XFP power updates, use the no enable xfp-power-updates command.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
interval seconds
Enter the keyword
interval followed by the polling interval in seconds.
Range: 120 to 6000 seconds
Default: 300 seconds (5 minutes)
Version 8.3.19.0 Replacement command for S4820T only. Replaces the enable
xfp-power-updates
command.
Version 8.3.10.0 Replacement command for S4810 only. Replaces the enable
xfp-power-updates
command.
interval seconds
Enter the keyword
interval followed by the polling interval in seconds.
Range: 120 to 6000 seconds
Default: 300 seconds (5 minutes)
Version 8.3.10.0 Deprecated command for S4810 only. Replaced by the enable
optic-info-update interval
command to update information on
temperature and power monitoring in the SNMP MIB.
Version 8.1.1.0 Introduced on E-Series ExaScale