Reference Guide

786 | IPv6 Basics
www.dell.com | support.dell.com
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
The Management port is enabled by default (no shutdown). If necessary, use the ipv6 address
command to assign an IPv6 address to the Management port.
Example
(show ipv6
interface)
FTOS#
FTOS#show ipv6 int te 0/5
TenGigabitEthernet 0/5 is up, line protocol is up
IPV6 is enabled
Link Local address: fe80::201:e8ff:fe8a:e8f7
Global Unicast address(es):
2001::1, subnet is 2001::/64
2002::1, subnet is 2002::/120
2003::1, subnet is 2003::/120
2004::1, subnet is 2004::/32
Global Anycast address(es):
Joined Group address(es):
ff02::1
ff02::2
ff02::1:ff00:1
ff02::1:ff8a:e8f7
ND MTU is 0
linecard slot-number (OPTIONAL) View information for a specific IPv6 linecard or
S-Series stack-unit
Range: 0 to 13 on a E1200, 0 to 6 on a E600, and 0 to 5 on a E300.
Range: 0 to 7 for C-Series
Range: 0 to 7 for S55 only
Range: 0 to 11 for S60, S4810, and S4820T
managementethernet slot/
port
(OPTIONAL) View information on an IPv6 Management port. Enter
the slot number (0-1) and port number zero (0).
loopback
(OPTIONAL) View information for IPv6 loopback interfaces.
port-channel
(OPTIONAL) View information for IPv6 port channels.
tengigabitethernet
(OPTIONAL) View information for an IPv6 tengigabitethernet
interface.
fortyGigE
(OPTIONAL) View information for an IPv6 fortygigabitethernet
interface.
vlan
(OPTIONAL) View information for IPv6 VLANs.
Version 8.3.19.0 Introduced on the S4820T
Version 8.3.7.0 Introduced on the S4810
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.4.2.1 Introduced on S-Series
Version 8.2.1.0 Introduced on E-Series ExaScale.
Support for the
managementethernet slot/port parameter was added.
Version 7.8.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series TeraScale