Reference Guide

800 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
bgp client-to-client reflection
c e
Allows you to enable route reflection between clients in a cluster.
Syntax
bgp client-to-client reflection
To disable client-to-client reflection, enter no bgp client-to-client reflection.
Defaults
Enabled when a route reflector is configured.
Command Modes
ROUTER BGP
Command
History
Usage
Information
Route reflection to clients is not necessary if all client routers are fully meshed.
Related
Commands
bgp cluster-id
c e
Assign a cluster ID to a BGP cluster with more than one route reflector.
Syntax
bgp cluster-id {ip-address | number}
To delete a cluster ID, use the
no bgp cluster-id {ip-address | number} command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Command
History
Version 8.3.19.0 Introduced on S4820T
Version 8.4.2.1 Introduced on C-Series and S4810
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
bgp cluster-id Assign ID to a BGP cluster with two or more route reflectors.
neighbor route-reflector-client Configure a route reflector and clients.
ip-address Enter an IP address as the route reflector cluster ID.
number
Enter a route reflector cluster ID as a number from 1 to 4294967295.
Version 8.3.19.0 Introduced on S4820T
Version 8.4.2.1 Introduced on C-Series and S4810
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale