Reference Guide

818 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Usage
Information
To view information on both incoming and outgoing routes, do not include the in and
out parameters in the debugging command. The in and out parameters cancel each
other; for example, if you enter
debug ip bgp in and then enter debug ip bgp out, you
will not information on the incoming routes.
Entering a no debug ip bgp command removes all configured debug commands for
BGP.
Related
Commands
debug ip bgp events
c e
Allows you to view information on local BGP state changes and other BGP events.
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name] events [in | out]
To disable debugging, use the
no debug ip bgp ipv6-address | peer-group
peer-group-name] events command.
Parameters
Command Modes
EXEC Privilege
Command
History
Usage
Information
Enter the no debug ip bgp command to remove all configured debug commands for
BGP.
debug ip bgp events View information about BGP events.
debug ip bgp keepalives View information about BGP keepalives.
debug ip bgp notifications View information about BGP notifications.
debug ip bgp updates View information about BGP updates.
ipv6-address
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
followed by the prefix length in the
/x format.
Range: /0 to /128
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group peer-group-name
(OPTIONAL) Enter the keyword peer-group followed by the
name of the peer group.
in (OPTIONAL) Enter the keyword in to view only events on
inbound BGP messages.
out
(OPTIONAL) Enter the keyword out to view only events on
outbound BGP messages.
Version 8.3.19.0 Introduced on S4820T
Version 8.4.2.1 Introduced on C-Series and S4810
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale