Reference Guide

IPv6 Border Gateway Protocol (IPv6 BGP) | 825
Command
History
Usage
Information
If you enable this command, use the capture bgp-pdu max-buffer-size command to
recompute the best path.
neighbor activate
c e
This command allows the specified neighbor/peer group to be enabled for the current
AFI/SAFI.
Syntax
neighbor {ipv6-address | peer-group-name} activate
To disable, use the no neighbor {ipv6-address | peer-group-name} activate command.
Parameters
Defaults
Disabled
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
By default, when a neighbor/peer group configuration is created in the Router BGP
context, it is enabled for the IPv6/Unicast AFI/SAFI. By using
activate in the new
context, the neighbor/peer group is enabled for AFI/SAFI.
neighbor advertisement-interval
c e
Set the advertisement interval between BGP neighbors or within a BGP peer group.
Syntax
neighbor {ipv6-address | peer-group-name} advertisement-interval seconds
Version 8.3.19.0 Introduced on S4820T
Version 8.4.2.1 Introduced on C-Series and S4810
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group-name
Identify a peer group by name.
activate Enter the keyword activate to enable the identified neighbor or
peer group in the new AFI/SAFI.
Version 8.3.19.0 Introduced on S4820T
Version 8.4.2.1 Introduced on C-Series and S4810
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale