Reference Guide

836 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Command
History
Usage
Information
If the number parameter is the same as the AS number used in the router bgp
command, the remote AS entry in the neighbor is considered an internal BGP peer
entry.
This command creates a peer and the newly created peer is disabled (shutdown).
Related
Commands
neighbor remove-private-as
c e
Remove private AS numbers from the AS-PATH of outgoing updates.
Syntax
neighbor {ipv6-address | peer-group-name} remove-private-as
To return to the default, use the no neighbor {ipv6-address | peer-group-name}
remove-private-as command.
Parameters
Defaults
Disabled (that is, private AS number are not removed).
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group-name
Enter the name of the peer group to enter the remote AS into
routing tables of all routers within the peer group.
number
Enter a number of the AS.
Range: 1 to 65535.
Version 8.3.19.0 Introduced on S4820T
Version 8.4.2.1 Introduced on C-Series and S4810
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
router bgp Enter the ROUTER BGP mode and configure routes in an AS.
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group-name
Enter the name of the peer group to remove the private AS numbers
Version 8.3.19.0 Introduced on S4820T
Version 8.4.2.1 Introduced on C-Series and S4810