Reference Guide

IPv6 Border Gateway Protocol (IPv6 BGP) | 839
To disable sending a COMMUNITY attribute, use the no neighbor {ipv6-address |
peer-group-name} send-community command.
Parameters
Defaults
Not configured and COMMUNITY attributes are not sent to neighbors.
Command Modes
ROUTER BGP
Command
History
neighbor shutdown
c e
Disable a BGP neighbor or peer group.
Syntax
neighbor {ipv6-address | peer-group-name} shutdown
To enable a disabled neighbor or peer group, use the no neighbor {ipv6-address |
peer-group-name} shutdown command.
Parameters
Defaults
Enabled (that is, BGP neighbors and peer groups are disabled.)
Command Modes
ROUTER BGP
Command
History
Usage
Information
Peers that are enabled within a peer group are disabled when their peer group is
disabled.
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group-name
Enter the name of the peer group to send a COMMUNITY
attribute to all routers within the peer group.
Version 8.3.19.0 Introduced on S4820T
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group-name
Enter the name of the peer group to disable or enable all routers
within the peer group.
Version 8.3.19.0 Introduced on S4820T
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale