Reference Guide

IPv6 Border Gateway Protocol (IPv6 BGP) | 845
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
Though FTOS does not generate a route due to backdoor config, there is an option for
injecting/sourcing a local route in presence of network backdoor config on a learned
route.
redistribute
c e
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the
no redistribution {connected | static} command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
ipv6-address prefix-length
Enter the IPv6 address in the x:x:x:x::x format followed by the
prefix length in the
/x format.
Range: /0 to /128
The
:: notation specifies successive hexadecimal fields of zeros.
Version 8.3.19.0 Introduced on S4820T
Version 8.4.2.1 Introduced on C-Series and S4810
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
connected
Enter the keyword connected to redistribute routes from physically connected
interfaces.
static
Enter the keyword static to redistribute manually configured routes.
These routes are treated as incomplete routes.
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an
established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all routes).