Reference Guide

846 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Command
History
Usage
Information
If you do not configure default-metric command, in addition to the redistribute
command, or there is no route map to set the metric, the metric for redistributed static
and connected is “0”.
To redistribute the default route (0
::0/0) configure the neighbor default-originate
command.
Related
Commands
redistribute isis
c e
Redistribute IS-IS routes into BGP.
Syntax
redistribute isis [level-1 | level-1-2 | level-2] [metric metric-value | metric-type
{external | internal}] [route-map map-name]
To stop redistribution of IS-IS routes, use the no redistribute isis command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Version 8.3.19.0 Introduced on S4820T
Version 8.4.2.1 Introduced on C-Series and S4810
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
neighbor default-originate Inject the default route.
level-1 | level-1-2
| level-2]
(OPTIONAL) Enter the type (level) of routes to redistribute.
metric (OPTIONAL) Assign metric to an interface for use with IPv6 information
metric-type
(OPTIONAL) The external link type associated with the default route
advertised into a routing domain. You must specify one of the following:
• external
• internal (Default)
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an
established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all routes).