Reference Guide

Control and Monitoring | 85
Usage
Information
The password is listed in the configuration file; you can view the password by
entering the
show running-config ftp command.
The password configured by the ip ftp password command is used when you use the
ftp: parameter in the copy command.
Related
Commands
ip ftp source-interface
c e s
Specify an interface’s IP address as the source IP address for FTP connections.
Syntax
ip ftp source-interface interface
Parameters
Defaults
The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command Modes
CONFIGURATION
Command
History
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
copy Copy files.
ip ftp username Set the user name for FTP sessions.
interface Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For Loopback interfaces, enter the keyword
loopback followed by a number
from zero (0) to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series: 1-128
E-Series: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale
• For SONET interface types, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1
to 4094.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094)
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series