Reference Guide

IPv6 Border Gateway Protocol (IPv6 BGP) | 863
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
timers bgp
c e
Allows you to adjust the BGP network timers for all neighbors.
Syntax
timers bgp keepalive holdtimer
To return to the default values, use the no timers bgp command.
Parameters
Defaults
keepalive
= 60 seconds; holdtimer = 180 seconds
Command Modes
ROUTER BGP
regular-expression [character]
Enter a regular expression then use one or a combination of
the following characters to match:
• . = (period) any single character (including a white
space)
•
* = (asterisk) the sequences in a pattern (0 or more
sequences)
• + = (plus) the sequences in a pattern (1 or more
sequences)
• ? = (question mark) sequences in a pattern (either 0 or 1
sequences). You must enter an escape sequence
(CTRL+v) prior to entering the ? regular
expression.
• [ ] = (brackets) a range of single-character patterns.
• ^ = (caret) the beginning of the input string. If the caret
is used at the beginning of a sequence or range, it
matches on everything BUT the characters specified.
• $ = (dollar sign) the end of the output string.
Version 8.3.19.0 Introduced on S4820T
Version 8.4.2.1 Introduced on C-Series and S4810
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
keepalive
Enter the time interval in seconds between which the E-Series sends keepalive
messages.
Range: 1 to 65535
Default: 60 seconds
holdtimer
Enter the time interval in seconds which the E-Series waits since the last
keepalive message before declaring a BGP peer dead.
Range: 3 to 65535
Default: 180 seconds