Reference Guide

874 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
To remove a default route, use the no neighbor {ipv6-address | peer-group-name}
default-originate command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
neighbor distribute-list
c e
Distribute BGP information via an established prefix list.
Syntax
neighbor [ipv6-address | peer-group-name] distribute-list prefix-list-name [in | out]
To delete a neighbor distribution list, use the
no neighbor [ipv6-address |
peer-group-name] distribute-list prefix-list-name [in | out] command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
ipv6-address
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group-name
Enter the name of the peer group to set the default route of all routers in
that peer group.
route-map map-name (OPTIONAL) Enter the keyword route-map followed by the name of a
configured route map.
Version 8.3.19.0 Introduced on S4820T
Version 8.4.2.1 Introduced on C-Series and S4810
Version 7.4.1.0 Introduced on E-Series TeraScale
ipv6-address
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group-name
Enter the name of the peer group to apply the distribute list filter to all
routers in the peer group.
prefix-list-name
Enter the name of an established prefix list.
If the prefix list is not configured, the default is permit (to allow all
routes).
in
Enter the keyword in to distribute only inbound traffic.
out
Enter the keyword out to distribute only outbound traffic.
Version 8.3.19.0 Introduced on S4820T