Reference Guide

876 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
To return to the default values, use the no neighbor ipv6-address | peer-group-name
maximum-prefix maximum command.
Parameters
Defaults
threshold
= 75
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
neighbor next-hop-self
c e
Allows you to configure the router as the next hop for a BGP neighbor.
Syntax
neighbor ipv6-address | peer-group-name next-hop-self
To return to the default setting, use the no neighbor ipv6-address | peer-group-name
next-hop-self command.
Parameters
Defaults
Disabled.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
ipv6-address
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group-name
(OPTIONAL) Enter the name of the peer group.
maximum
Enter a number as the maximum number of prefixes allowed for this BGP
router.
Range: 1 to 4294967295.
threshold
(OPTIONAL) Enter a number to be used as a percentage of the maximum
value. When the number of prefixes reaches this percentage of the
maximum value, the E-Series software sends a message.
Range: 1 to 100 percent.
Default: 75
warning-only
(OPTIONAL) Enter the keyword warning-only to set the router to send a
log message when the maximum value is reached. If this parameter is not
set, the router stops peering when the maximum number of prefixes is
reached.
Version 8.3.19.0 Introduced on S4820T
Version 8.4.2.1 Introduced on C-Series and S4810
Version 7.4.1.0 Introduced on E-Series TeraScale
ipv6-address
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group-name
(OPTIONAL) Enter the name of the peer group.