Reference Guide

880 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
redistribute
c e
Redistribute routes into BGP.
Syntax
redistribute [connected | static] [route-map map-name]
To disable redistribution, use the
no redistribution [connected | static] [route-map
map-name] command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
If you do not configure default-metric command, in addition to the redistribute
command, or there is no route map to set the metric, the metric for redistributed static
and connected is “0”.
To redistribute the default route (0
::0/0) configure the neighbor default-originate
command.
Related
Commands
show ip bgp ipv6 unicast
c e
View the current MBGP routing table for the E-Series.
Syntax
show ip bgp ipv6 unicast [network [network-mask] [length]]
connected
Enter the keyword connected to redistribute routes from physically connected
interfaces.
static
Enter the keyword static to redistribute manually configured routes.
These routes are treated as incomplete routes.
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an
established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all routes).
Version 8.3.19.0 Introduced on S4820T
Version 8.4.2.1 Introduced on C-Series and S4810
Version 7.4.1.0 Introduced on E-Series TeraScale
neighbor default-originate Inject the default route.