Reference Guide

Control and Monitoring | 89
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
You cannot delete a terminal connection.
Related
Commands
linecard
c e
Pre-configure a line card in a currently empty slot of the system or a different line
card type for the slot. To pre-configure a 4-port 40G line card, refer to the linecard
command.
Syntax
linecard number card-type
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
Use this command only for empty slots or a slot where you have hot-swapped a
different line card type. Before inserting a card of a different type into the
pre-configured slot, execute the
no linecard number command. The following
screenshot shows the current supported C-Series line cards, along with their “card
types” (card-type IDs).
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
access-class Restrict incoming connections to a particular IP address in an IP access control
list (ACL).
password Specify a password for users on terminal lines.
show linecard Display the line card(s) status.
number Enter the number of the slot.
C-Series Range: 0-7
E-Series Range: 0 to 13 on a E1200/E1200i, 0 to 6 on a E600/E6001, and 0 to 5
on a E300.
card-type Enter the line card ID ( the Supported Hardware section in the Release Notes).
Version 8.1.1.2 Introduced on E-Series ExaScale E600i
Version 8.1.1.0 Introduced on E-Series ExaScale E1200i
Version 7.5.1.0 Introduced on C-Series
E-Series original Command