Reference Guide

890 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Related
Commands
show ip bgp ipv6 unicast peer-group
c e
Allows you to view information on the BGP peers in a peer group.
Syntax
show ip bgp ipv6 unicast peer-group [peer-group-name [summary]]
Parameters
Command Modes
EXEC
Sent messages The line displays the number of BGP messages sent, the number of
notifications (error messages) and the number of messages waiting
in a queue for processing.
Received updates This line displays the number of BGP updates received and sent.
Minimum time Displays the minimum time, in seconds, between advertisements.
(list of inbound and outbound
policies)
Displays the policy commands configured and the names of the
Route map, AS-PATH ACL or Prefix list configured for the policy.
For address family: Displays IPv6 Unicast as the address family.
BGP table version Displays the which version of the primary BGP routing table the
router and the neighbor are using.
accepted prefixes Displays the number of network prefixes accepted by the router
and the amount of memory used to process those prefixes.
Prefix advertised Displays the number of network prefixes advertised, the number
rejected and the number withdrawn from the BGP routing table.
Connections established Displays the number of TCP connections established and dropped
between the two peers to exchange BGP information.
Last reset Displays the amount of time since the peering session was last
reset. Also states if the peer resets the peering session.
If the peering session was never reset, the word never is displayed.
Local host: Displays the peering address of the local router and the TCP port
number.
Foreign host: Displays the peering address of the neighbor and the TCP port
number.
Table 27-3. show ip bgp neighbors Command Fields (continued)
Lines beginning with Description
show ip bgp ipv6 unicast View the current BGP routing table.
peer-group-name
(OPTIONAL) Enter the name of a peer group to view information about
that peer group only.
summary
(OPTIONAL) Enter the keyword summary to view status information of
the peers in that peer group.
The output is the same as that found in show ip bgp ipv6 unicast
summary command