Reference Guide

iSCSI Optimization | 895
Defaults
See above.
Command Modes
CONFIGURATION
Command
History
Usage
Information
By default, iSCSI flows are assigned to dot1p priority 4. Dell Force10 recommends changing
the dot1p priority-queue setting to 0 (zero).
iscsi enable
Globally enable iSCSI optimization.
Syntax
iscsi enable
To disable iSCSI optimization, use the no iscsi command.
Parameters
Defaults
Enabled.
Command Modes
CONFIGURATION
Command
History
iscsi priority-bits
Configure the priority bitmap to be advertised in iSCSI application TLVs.
Syntax
iscsi priority-bits
dscp dscp-value
Enter the DSCP value assigned to the incoming packets in an iSCSI session.
The valid range is 0 to 63.
Default: The DSCP value in ingress packets is not changed.
remark
Marks the incoming iSCSI packets with the configured dot1p or DSCP value when
they egress to the switch.
Default: The dot1and DSCP values in egress packets are not changed.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
enable Enter the keyword enable to enable the iSCSI optimization feature.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module