Reference Guide

896 | iSCSI Optimization
www.dell.com | support.dell.com
To remove the configured priority bitmap, use the no iscsi priority-bits command.
Defaults
4 (0x10 in the bitmap)
Command Modes
PROTOCOL LLDP (only on global, not on interface)
Command
History
iscsi profile-compellant
Configure the auto-detection of Compellent arrays on a port.
Syntax
iscsi profile-compellent
Defaults
Compellent disk arrays are not detected.
Command Modes
INTERFACE
Command
History
iscsi target port
Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication will
be monitored.
Syntax
iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-address]
To remove the configured iSCSI target ports or IP addresses, use the no iscsi target port command.
Parameters
Defaults
860, 3260.
Command Modes
CONFIGURATION
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
tcp-port-2...tcp-
port-16
Enter the tcp-port number of the iSCSI target ports.
The
tcp-port-n is the TCP port number or a list of TCP port numbers on which the
iSCSI target listens to requests. Separate port numbers with a comma.
Default: 860, 3260.
ip-address
(Optional) Enter the ip-address that the iSCSI will monitor.
The ip-address specifies the IP address of the iSCSI target.