Reference Guide

906 | Intermediate System to Intermediate System (IS-IS)
www.dell.com | support.dell.com
clns host
e
Define a name-to-network service mapping point (NSAP) mapping that can then be used with
commands that require NSAPs and system IDs.
Syntax
clns host name nsap
Parameters
Defaults
Not configured.
Command Modes
ROUTER ISIS
Command
History
Related
Commands
Usage
Information
Use this command to configure a shortcut name that can used instead of entering a long string
of numbers associated with an NSAP address.
debug isis
e
Enable debugging for all IS-IS operations.
Syntax
debug isis
To disable debugging of IS-IS, enter no debug isis.
Command Modes
EXEC Privilege
Command
History
Usage
Information
Entering debug isis enables all debugging parameters.
Use this command to display all debugging information in one output. To turn off debugging, you
normally enter separate no forms of each command. Enter the no debug isis command to disable all
debug messages for IS-IS at once.
name
Enter an alphanumeric string to identify the name-to-NSAP mapping.
nsap Enter a specific NSAP address that will be associated with the name parameter.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.12.0 Introduced on S4810
hostname dynamic
Enables dynamic learning of hostnames from routers in the domain and
allows the routers to advertise the hostnames in LSPs.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.12.0 Introduced on S4810