Reference Guide

Intermediate System to Intermediate System (IS-IS) | 935
To end redistribution or disable any of the specified keywords, enter the
no redistribute {static | connected | rip} [metric metric-value] [metric-type {external |
internal}] [level-1 | level-1-2 | level-2] [route-map map-name] command.
Parameters
Defaults
metric metric-value = 0; metric-type= internal; level-2
Command Modes
ROUTER ISIS (for IPv4)
CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
Usage
Information
To redistribute a default route (0.0.0.0/0), configure the default-information originate command.
Changing or disabling a keyword in this command will not affect the state of the other command
keywords.
When an LSP with an internal metric is received, the FTOS considers the route cost taking into
consideration the advertised cost to reach the destination.
Redistributed routing information is filtered with the distribute-list out command to ensure that the
routes are properly are passed to the receiving routing protocol.
connected
Enter the keyword connected redistribute active routes into IS-IS.
rip Enter the keyword rip to redistribute RIP routes into IS-IS.
static Enter the keyword static to redistribute user-configured routes into IS-IS.
metric metric-value
(OPTIONAL) Assign a value to the redistributed route.
Range: 0 to 16777215
Default: 0. You should use a value that is consistent with the destination
protocol.
metric-type {external |
internal}
(OPTIONAL) The external link type associated with the default route
advertised into a routing domain. You must specify one of the following:
• external
• internal
level-1
(OPTIONAL) Routes are independently redistributed into IS-IS as Level 1
routes.
level-1-2
(OPTIONAL) Routes are independently redistributed into IS-IS as Level-1-2
routes.
level-2
(OPTIONAL) Routes are independently redistributed into IS-IS as Level 2
routes.
This is the default.
route-map map-name (OPTIONAL) If the route-map argument is not entered, all routes are
redistributed. If a
map-name value is not specified, then no routers are
imported.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.12.0 Introduced on S4810
Version 7.5.1.0 Introduced IPv6 ISIS support
Version 6.3.1.0 Introduced