Reference Guide

946 | Intermediate System to Intermediate System (IS-IS)
www.dell.com | support.dell.com
Usage
Information
Use this command to confirm that the neighbor adjacencies are operating correctly. If you suspect that
they are not, you can verify the specified area addresses of the routers by using the show isis neighbors
command.
show isis protocol
e
Display IS-IS routing information.
Syntax
show isis protocol
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 29-9. Command Example: show isis protocol
show isis traffic
e
This command enables you to display IS-IS traffic interface information.
Syntax
show isis traffic [interface]
Version 8.3.19.0 Introduced on S4820T
Version 8.3.12.0 Introduced on S4810
FTOS#show isis protocol
IS-IS Router: <Null Tag>
System Id: F100.E120.0013 IS-Type: level-1-2
Manual area address(es):
49.0000.0001
Routing for area address(es):
49.0000.0001
Interfaces supported by IS-IS:
GigabitEthernet 1/0 - IP - IPv6
GigabitEthernet 1/1 - IP - IPv6
GigabitEthernet 1/10 - IP - IPv6
Loopback 0 - IP - IPv6
Redistributing:
Distance: 115
Generate narrow metrics: level-1-2
Accept narrow metrics: level-1-2
Generate wide metrics: none
Accept wide metrics: none
Multi Topology Routing is enabled in transition mode.
FTOS#
Identifies that MT IS-IS
is enabled.