Reference Guide

Link Aggregation Control Protocol (LACP) | 953
Defaults
This command has no default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
lacp long-timeout
c e
Configure a long timeout period (30 seconds) for an LACP session.
Syntax
lacp long-timeout
To reset the timeout period to a short timeout (1 second), use the no lacp long-timeout
command.
Defaults
1 second
Command Modes
INTERFACE (conf-if-po-number)
Command
History
interface
in | out
(OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
Optionally, enter an
in or out parameter:
• Receive enter
in
• Transmit enter out
Version 8.3.19.0 Introduced on S4820T
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced on E-Series
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Support added for S-Series