Reference Guide

954 | Link Aggregation Control Protocol (LACP)
www.dell.com | support.dell.com
Usage
Information
This command applies to dynamic port-channel interfaces only. When applied on a
static port-channel, the command has no effect.
Related
Commands
lacp port-priority
c e s
Configure the port priority to influence which ports will be put in standby mode when
there is a hardware limitation that prevents all compatible ports from aggregating.
Syntax
lacp port-priority priority-value
To return to the default setting, use the no lacp port-priority priority-value command.
Parameters
Defaults
32768
Command Modes
INTERFACE
Command
History
lacp system-priority
c e s
Configure the LACP system priority.
Syntax
lacp system-priority priority-value
Version 7.5.1.0 Support added for C-Series
Version 7.5.1.0 Introduced on E-Series
show lacp Display the lacp configuration
priority-value
Enter the port-priority value. The higher the value number the lower the
priority.
Range: 1 to 65535
Default: 32768
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced on E-Series