Reference Guide

956 | Link Aggregation Control Protocol (LACP)
www.dell.com | support.dell.com
Table 30-1. LACP Modes
port-channel-protocol lacp
c e s
Enable LACP on any LAN port.
Syntax
port-channel-protocol lacp
To disable LACP on a LAN port, use the no port-channel-protocol lacp command.
Command Modes
INTERFACE
Command
History
Related
Commands
show lacp
c e s
Display the LACP matrix.
Syntax
show lacp port-channel-number [sys-id | counters]
Mode Function
active
An interface is in an active negotiating state in this mode. LACP runs on any link
configured in the active state and also automatically initiates negotiation with other
ports by initiating LACP packets.
passive
An interface is not in an active negotiating state in this mode. LACP runs on any link
configured in the passive state. Ports in a passive state respond to negotiation requests
from other ports that are in active states. Ports in a passive state respond to LACP
packets.
off
An interface can not be part of a dynamic port channel in the off mode. LACP will
not run on a port configured in the off mode.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 6.2.1.1 Introduced
show lacp Display the LACP information.
show interfaces port-channel Display information on configured Port Channel groups.