Reference Guide

964 | Layer 2
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
For information on the specific trap sent and the corresponding Syslog refer to
Chapter 60, SNMP Traps.
mac-address-table station-move time-interval
e
Reduce the amount of time FTOS takes to detect aged entries and station moves.
Syntax
[no] mac-address-table station-move time-interval number
Parameters
Defaults
5000ms
Command Modes
CONFIGURATION
Command
History
Usage
Information
FTOS takes 4 to 5 seconds to detect aged entries and station moves because the MAC
address table scanning routine runs every 5000 ms by default. To achieve faster
detection, reduce the scanning interval.
mac-address-table station-move refresh-arp
c e s
Ensure that ARP refreshes the egress interface when a station move occurs due to a
topology change.
Syntax
[no] mac-address-table station-move refresh-arp
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Version 8.3.19.0 Introduced on S4820T.
Version 8.3.7.0 Introduced on S4810
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
time-interval number Select the interval of the successive scans of the MAC address table
that are used to detect a aged entries and station moves.
Range: 500 to 5000ms
Version 7.8.1.0 Introduced on E-Series