Reference Guide

974 | Layer 2
www.dell.com | support.dell.com
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
show mac-address-table
c e s
Display the MAC address table.
Syntax
show mac-address-table [dynamic | static] [address mac-address | interface interface |
vlan
vlan-id] [count [vlan vlan-id] [interface interface-type [slot [/port]]]]
stack-unit unit_number
(REQUIRED) Enter the keyword linecard followed by a stack
member number to select the linecard for which to gather
information.
S-Series Range: 0 to 1
port-set port-pipe
(REQUIRED) Enter the keyword port-set followed by a Port-Pipe
number to select the Port-Pipe for which to gather information.
S-Series Range: 0 or 1
address mac-addr (OPTIONAL) Enter the keyword address followed by a MAC
address in the nn:nn:nn:nn:nn:nn format to display information on
that MAC address.
dynamic
(OPTIONAL) Enter the keyword dynamic to display only those
MAC addresses learned dynamically by the switch.
static
(OPTIONAL) Enter the keyword static to display only those MAC
address specifically configured on the switch.
interface interface (OPTIONAL) Enter the keyword interface followed by the interface
type, slot and port information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number:
S-Series Range: 1 to 128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN ID to
display the MAC address assigned to the VLAN.
Range: 1 to 4094.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 7.6.1.0 This version of the command introduced for S-Series