Reference Guide

Layer 2 | 981
Gi 5/84 2 2 0 0
0
Gi 5/84 * 5 0 0
0
FTOS#show mac learning-limit interface gig 5/84 vlan 2
Interface Vlan Learning Dynamic Static
Unknown SA
Slot/port Id Limit MAC count MAC count
Drops
Gi 5/84 2 2 0 0
0
Example
(C-Series &
S-Series)
C-Series/S-Series output:
FTOS#show mac learning-limit
Interface Learning Dynamic Static
Unknown SA
Slot/port Limit MAC count MAC count Drops
Gi 1/0 10 0 0
0
Gi 1/1 5 0 0
0
FTOS#show mac learning-limit interface gig 1/0
Interface Learning Dynamic Static
Unknown SA
Slot/port Limit MAC count MAC count Drops
Gi 1/0 10 0 0
0
Virtual LAN (VLAN) Commands
The following commands configure and monitor Virtual LANs (VLANs). VLANs
are a virtual interface and use many of the same commands as physical interfaces.
You can configure an IP address and Layer 3 protocols on a VLAN called
Inter-VLAN routing. FTP, TFTP, ACLs and SNMP are not supported on a VLAN.
Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the
VRRP state of a VLAN interface may continually switch between Master and
Backup.
• description
• default vlan-id
• default-vlan disable
• enable vlan-counters
•name
• show config
• show vlan