Reference Guide

Layer 2 | 983
Command
History
Usage
Information
To return VLAN 1 as the Default VLAN, use this command syntax (default-vlan-id 1).
The Default VLAN contains only untagged interfaces.
Related
Commands
default-vlan disable
c e s
Disable the default VLAN so that all switchports are placed in the Null VLAN until
they are explicitly configured as a member of another VLAN.
Defaults
The default VLAN is enabled.
Command Modes
CONFIGURATION
Command
History
Usage
Information
no default vlan disable is not listed in the running-configuration, but when the default
VLAN is disabled,
default-vlan disable is listed in the running-configuration.
enable vlan-counters
e
x
Display VLAN counters for ingress and/or egress hardware. You must be in restricted
mode to use this command.
Syntax
enable vlan-output-counters [ingress | egress | all]
To return to the default (disabled), use the no enable vlan-output-counters command.
Defaults
Disabled — VLAN counters are disabled in hardware (all linecards/port-pipes) by
default.
Command Modes
CONFIGURATION
Version 8.3.19.0 Introduced on S4820T.
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
interface vlan Configure a VLAN.
Version 8.3.19.0 Introduced on S4820T.
Version 8.3.7.0 Introduced no S4810
Version 8.3.1.0 Introduced