Users Guide

Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 1d23h42m
Dynamic Counters
By default, counting is enabled for IPFLOW, IPACL, L2ACL, L2FIB.
For the remaining applications, Dell Networking OS automatically turns on counting when you enable the application, and is turned
o when you disable the application.
NOTE: If you enable more than four counter-dependent applications on a port pipe, there is an impact on line rate
performance.
The following counter-dependent applications are supported by Dell Networking OS:
• Egress VLAN
• Ingress VLAN
• Next Hop 2
• Next Hop 1
• Egress ACLs
• ILM
• IP FLOW
• IP ACL
• IP FIB
• L2 ACL
• L2 FIB
Clearing Interface Counters
The counters in the show interfaces command are reset by the clear counters command. This command does not clear
the counters any SNMP program captures.
To clear the counters, use the following the command.
• Clear the counters used in the show interface commands for all VRRP groups, VLANs, and physical interfaces or selected
ones. Without an interface specied, the command clears all interface counters.
EXEC Privilege mode
clear counters [interface] [vrrp [vrid] | learning-limit]
(OPTIONAL) Enter the following interface keywords and slot/port or number information:
– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
– For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
– For the Management interface on the stack-unit, enter the keyword ManagementEthernet then the slot/port
information. The slot range is from 0 to 1. The port range is 0.
– For a port channel interface, enter the keywords port-channel then a number.
– For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
– (OPTIONAL) To clear statistics for all VRRP groups congured, enter the keyword vrrp. Enter a number from 1 to 255 as
the vrid.
– (OPTIONAL) To clear unknown source address (SA) drop counters when you congure the MAC learning limit on the
interface, enter the keywords learning-limit.
400
Interfaces