Users Guide

Applying Layer 2 Match Criteria on a Layer 3 Interface
To process Layer 3 packets that contain a dot1p (IEEE 802.1p) VLAN Layer 2 header, congure VLAN tags on a Layer 3 port
interface which is congured with an IP address but has no VLAN associated with it. You can also congure a VLAN sub-interface on
the port interface and apply a policy map that classies packets using the dot1p VLAN ID.
To apply an input policy map with Layer 2 match criteria to a Layer 3 port interface, use the service-policy input policy-
name layer 2 command in Interface conguration mode.
To apply a Layer 2 policy on a Layer 3 interface:
1. Congure an interface with an IP address or a VLAN sub-interface
CONFIGURATION mode
Dell(conf)# interface fo 1/4
INTERFACE mode
Dell(conf-if-fo-1/4)# ip address 90.1.1.1/16
2. Congure a Layer 2 QoS policy with Layer 2 (Dot1p or source MAC-based) match criteria.
CONFIGURATION mode
Dell(conf)# policy-map-input l2p layer2
3. Apply the Layer 2 policy on a Layer 3 interface.
INTERFACE mode
Dell(conf-if-fo-1/4)# service-policy input l2p layer2
Applying DSCP and VLAN Match Criteria on a Service Queue
You can congure Layer 3 class maps which contain both a Layer 3 Dierentiated Services Code Point (DSCP) and IP VLAN IDs as
match criteria to lter incoming packets on a service queue on the switch.
To congure a Layer 3 class map to classify trac according to both an IP VLAN ID and DSCP value, use the match ip vlan
vlan-id command in class-map input conguration mode. You can include the class map in a policy map, and apply the class and
policy map to a service queue using the service-queue command. In this way, the system applies the match criteria in a class
map according to queue priority (queue numbers closer to 0 have a lower priority).
To congure IP VLAN and DSCP match criteria in a Layer 3 class map, and apply the class and policy maps to a service queue:
1. Create a match-any or a match-all Layer 3 class map, depending on whether you want the packets to meet all or any of the
match criteria. By default, a Layer 3 class map is created if you do not enter the layer2 option with the class-map command.
When you create a class map, you enter the class-map conguration mode.
CONFIGURATION mode
Dell(conf)#class-map match-all pp_classmap
2. Congure a DSCP value as a match criterion.
CLASS-MAP mode
Dell(conf-class-map)#match ipdscp 5
3. Congure an IP VLAN ID as a match criterion.
CLASS-MAP mode
Dell(conf-class-map)#match ip vlan 5
4. Create a QoS input policy.
Quality of Service (QoS)
695