Owners Manual

To disable logging, use the no logging command.
Parameters
ip-address Enter the IPv4 address in dotted decimal format.
ipv6-address Enter the IPv6 address in the x:x:x:x::X format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
hostname Enter the name of a host already configured and recognized
by the switch.
udp Enter the keyword udp to enable transmission of log
message over UDP followed by port number. The default
port is 514
tcp Enter the keyword tcp to enable transmission of log
message over TCP followed by port number.
vrf vrf-name (Optional) Enter the keyword vrf and then the name of the
VRF to enable the logging process in VRF mode.
NOTE: Use this attribute to specify the VRF that is used
to contact the host. By default, the default VRF is used.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Added udp and tcp keywords for the S4810, S4820T, S6000,
Z9000, and MXL.
Version 9.4.
(0.0)
Added support for VRF.
Version 9.2(1.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.1.0 Added support for IPv6.
1594
Simple Network Management Protocol (SNMP) and Syslog