Owners Manual

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you do not use the statistics parameter, both hardware and DCBx counters
clear.
dcb-input
To apply pause or flow control for specified priorities using a configure delay time, create a DCB input
policy.
Syntax
dcb-input policy-name
To delete the DCB input policy, use the no dcb-input command.
Parameters
policy-name Maximum: 32 alphanumeric characters.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.6(0.0) Removed from the S-series. Replaced by the dcb-map
commands.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
As soon as you apply a DCB policy with PFC enabled on an interface, DCBx starts
exchanging information with PFC-enabled peers. The IEEE802.1Qbb, CEE, and CIN
522
Data Center Bridging (DCB)