Owners Manual

To remove a priority-group configuration in a DCB map, enter the no priority-
group bandwidth pfc command.
By default, equal bandwidth is assigned to each dot1p priority in a priority group.
Use the bandwidth parameter to configure the bandwidth percentage assigned to
a priority group. The sum of the bandwidth allocated to all priority groups in a DCB
map must be 100% of the bandwidth on the link. You must allocate at least 1% of
the total port bandwidth to each priority group.
dcb-map stack-unit all stack-ports all
Apply the specified DCB map on all ports of the switch stack.
Syntax
dcb-map stack-unit all stack-ports all dcb-map-name
To remove the PFC and ETS settings in a DCB map from all stack units, use the no
dcb-map stack-unit all stack-ports all command.
Parameters
dcb-map-
name
Enter the name of the DCB map.
Defaults None
Command
Modes
CONFIGURATION
Command
History
Version 9.3(0.0) Introduced on the S4810 and S6000 platforms.
Usage
Information
The dcb-map stack-unit all stack-ports all command overwrites any
previous DCB maps applied to stack ports.
show qos dcb-map
Display the DCB parameters configured in a specified DCB map.
Syntax
show qos dcb-map map-name
Parameters
map-name Displays the PFC and ETS parameters configured in the
specified map.
576
Data Center Bridging (DCB)