Reference Guide

configuration to the ACL agent whenever the ACL agent is registered with the port mirroring application
or when flow-based monitoring is enabled.
The show monitor session session-id command has been enhanced to display the Type field in
the output, which indicates whether a particular session is enabled for flow-monitoring.
Example Output of the show Command
Dell(conf-mon-sess-0)#do show monitor session 0
SessID Source Destination Dir Mode Source IP Dest IP
------ ------ ----------- --- ---- --------- --------
0 Te 0/0 Te 0/2 rx Flow N/A N/
A
The show config command has been modified to display monitoring configuration in a particular
session.
Example Output of the show Command
(conf-mon-sess-11)#show config
!
monitor session 11
flow-based enable
source GigabitEthernet 13/0 destination GigabitEthernet 13/1 direction
both
The show ip | mac | ipv6 accounting commands have been enhanced to display whether
monitoring is enabled for traffic that matches with the rules of the specific ACL.
Example Output of the show Command
Dell# show ip accounting access-list
!
Extended Ingress IP access list kar on GigabitEthernet 10/0
Total cam count 1
seq 5 permit ip 192.168.20.0/24 173.168.20.0/24 monitor
Dell#show ipv6 accounting access-list
!
Ingress IPv6 access list kar on GigabitEthernet 10/0
Total cam count 1
seq 5 permit ipv6 22::/24 33::/24 monitor
150
Access Control Lists (ACLs)