Reference Guide

CONFIGURATION mode
redundancy auto-failover-limit
(no parameters)
Disabling Auto-Reboot
To disable auto-reboot, use the following command.
• Prevent a failed RPM from rebooting after a failover.
CONFIGURATION mode
redundancy disable-auto-reboot
Manually Synchronizing RPMs
To manually synchronize RPMs at any time, use the following command.
• Manually synchronize RPMs.
EXEC Privilege mode
redundancy synchronize full
Online Insertion and Removal
You can add, replace, or remove chassis components while the chassis is operating.
This section contains the following sub-sections:
• RPM Online Insertion and Removal
• Linecard Online Insertion and Removal
RPM Online Insertion and Removal
Dell Networking systems are functional with only one RPM.
If you insert a second RPM, it comes online as the standby RPM.
To see SFM status information, use the show sfm all command.
Example of the show rpm all Command
Dell#show rpm all
-- Route Processor Modules --
Slot Status NxtBoot Version
-----------------------------------------------------------
0 active online 7-5-1-71
1 not present
%RPM0-P:CP %POLLMGR-2-ALT_RPM_STATE: Alternate RPM is present
%RPM0-P:CP %IRC-6-IRC_COMMUP: Link to peer RPM is up
%RPM1-S:CP %RAM-5-RPM_STATE: RPM1 is in Standby State
Dell#show rpm all
-- Route Processor Modules --
Slot Status NxtBoot Version
-------------------------------------------------------------
390
High Availability (HA)