Users Guide

● icmp for internet control message protocol
● ip for any internet protocol
● tcp for transmission control protocol
● udp for user datagram protocol
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all traffic is subject to the filter.
host ip-address Enter the keyword host then he IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
bit (OPTIONAL) For the TCP protocol type only, enter one or a combination of the
following TCP flags:
● ack = acknowledgement
● fin = finish (no more data from the user)
● psh = push function
● rst = reset the connection
● syn = synchronize sequence number
● urg = urgent field
operator (OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical
operand:
● eq = equal to
● neq = not equal to
● gt = greater than
● lt= less than
● range = inclusive range of ports (you must specify two ports for the
portcommand parameter.)
Defaults None
Command Modes REDIRECT-LIST
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series.
7.5.1.0 Introduced on the E-Series.
1090 Policy-based Routing (PBR)