Users Guide

ip pim neighbor-filter
To prevent a router from participating in protocol independent multicast (PIM), configure this feature.
S4820T
Syntax
ip pim [vrf vrf-name] neighbor-filter {access-list}
To remove the restriction, use the no ip pim [vrf vrf-name] neighbor-filter {access-
list} command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to prevent
that VRF from participating in PIM.
NOTE: Applies to specific VRF if input is provided, else applies to default VRF.
access-list Enter the name of a standard access list. Maximum 16 characters.
Defaults none
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series and S-Series.
7.6.1.0 Introduced on the E-Series.
Usage
Information
Do not enter this command before creating the access-list.
ip pim query-interval
Change the frequency of PIM Router-Query messages.
Syntax
ip pim query-interval seconds
To return to the default value, use the no ip pim query-interval seconds command.
Parameters
seconds Enter a number as the number of seconds between router query messages. The
range is from 0 to 65535. The default is 30 seconds.
Defaults 30 seconds
Command Modes INTERFACE
PIM-Sparse Mode (PIM-SM) 1103