Users Guide

To disable authorization checking for EXEC level commands, use the no aaa authorization exec
command.
Parameters
name Define a name for the list of authorization methods.
default Define the default list of authorization methods.
local Use the authorization parameters on the system to perform authorization.
tacacs+ Use the TACACS+ protocol to perform authorization.
none Enter the keyword none to apply no authorization.
Defaults none
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Added support for RADIUS.
privilege level (CONFIGURATION mode)
Change the access or privilege level of one or more commands.
Syntax
privilege mode {level level command | reset command}
To delete access to a level and command, use the no privilege mode level level command
command.
Parameters
mode Enter one of the following keywords as the mode for which you are controlling
access:
● configure for CONFIGURATION mode
● exec for EXEC mode
● interface for INTERFACE modes
● line for LINE mode
● route-map for ROUTE-MAP mode
● router for ROUTER OSPF, ROUTER RIP, ROUTER ISIS and ROUTER BGP
modes
level level Enter the keyword level then a number for the access level. The range is from 0
to 15.
Level 1 is EXEC mode and Level 15 allows access to all CLI modes and commands.
1256 Security