Users Guide

RADIUS Commands
The following RADIUS commands are supported by Dell Networking OS.
aaa radius group
Configure the RADIUS server group that is used for Authentication, Authorization and Accounting.
Syntax
aaa radius group group-name
To remove the RADIUS group configuration, use the no aaa radius group group-name command.
Parameters
group-name Enter the name of the RADIUS server group.
Defaults none
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage
Information
You can use this command to configure the group of Radius servers used for Authentication,
Authorization, and Accounting purposes.
If the RADIUS group is not configured for Authentication, Authorization, and Accounting, then globally
configured Radius servers are used for the purposes.
When the RADIUS group is removed, the AAA configuration is also removed.
Example
debug radius
View RADIUS transactions to assist with troubleshooting.
Syntax
debug radius
To disable debugging of RADIUS, use the no debug radius command.
Defaults Disabled.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
1274 Security