Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4820T

1311

Version Description

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.4(0.0) Introduced on the S-Series and Z9000.

Usage

Information

If you configure a VRF for an SSH session, then you need not explicitly mention the same VRF for the

SSH client sessions intended for that VRF. The vrf attribute in the ip ssh vrf command is applicable

for both the SSH client as well as the COPY (SCP) commands.

Example

Dell(conf)#ip ssh vrf vrf1

Dell(conf)#do ssh 10.10.10.2 -l admin

Dell(conf)#no ip ssh vrf vrf1

ip ssh source-interface

Specifies an interface’s IP address as the source IP address for an outgoing SSH connections.

Syntax

ip ssh source-interface interface

To delete a source interface, use the no ip ssh source-interface command.

Parameters

interface

Enter the following keywords and slot/port or number information:

● For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the

slot/port information.

● For a Loopback interface, enter the keyword loopback then a number from 0

to 16383.

● For a port channel interface, enter the keywords port-channel then a

number.

● For a Null interface, enter the keyword null then the Null interface number.

●

For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Defaults Not configured.

Command Modes CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.