Users Guide

auth (OPTIONAL) Enter the keyword auth to specify authentication of a packet
without encryption.
noauth (OPTIONAL) Enter the keyword noauth to specify no authentication of a packet.
priv (OPTIONAL) Enter the keyword priv to specify both authentication and then
scrambling of the packet.
community-
string
Enter a text string (up to 20 characters long) as the name of the SNMP
community.
NOTE: For version 1 and version 2c security models, this string represents the
name of the SNMP community. The string can be set using this command;
however, Dell Networking OS recommends setting the community string using
the snmp-server community command before executing this command.
For version 3 security model, this string is the USM user security name.
udp-port port-
number
(OPTIONAL) Enter the keywords udp-port followed by the port number of the
remote host to use. The range is from 0 to 65535. The default is 162.
notification-type (OPTIONAL) Enter one of the following keywords for the type of trap to be sent to
the host:
● bgp — Enable BGP state change traps.
● ecfm — Enable ECFM state change traps.
● entity — Enable entity change traps.
● envmon — Enable SNMP environmental monitor traps.
● eoam — Enable EOAM state change traps
● ets — Enable ets traps
● fips — Enable FIP Snooping state change traps
●
lacp — Enable LACP state change traps.
● isis — Enable ISIS adjacency change traps
● pfc — Enable pfc traps
● snmp — Enable SNMP trap
● stp — Enable 802.1d state change traps
● vlt — Enable VLT traps
● vrrp — Enable VRRP state change traps
● xstp — Enable 802.1s, 802.1w, and PVST+ state change traps
The default is all trap types are sent to host.
Defaults As above.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.1(0.0) Added support for config and ecmp traps.
1360 Simple Network Management Protocol (SNMP) and Syslog