Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4820T

1481

Defaults Not configured.

Command Modes CONF-IF-VLAN

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.10(0.0) Introduced on the S6100–ON.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.11.1 Introduced on the Z9000.

8.2.1.0 Introduced on the E-Series.

7.6.1.0 Introduced on the C-Series and S-Series.

Usage

Information

Enable the stackable VLAN (using the vlan-stack compatible command) on the VLAN prior to

adding a member to the VLAN.

Commands

● vlan-stack compatible — enables stackable VLAN on a VLAN.

stack-unit stack-group

Configure a stacking group specified by an ID.

Syntax

[no] stack-unit unit-id stack-group stack-group-id

To remove the current stack group configuration, use the no stack-unit unit-id stack-group

stack-id command.

Parameters

unit-id

Enter the stack unit ID.

stack-group-id

Enter the stack group ID. The range is from 0 to 16.

Command Modes CONFIGURATION