Users Guide

Example
Dell# show ip accounting access-list
!
Standard Ingress IP access list test on TenGigabitEthernet 0/88
Total cam count 2
seq 5 permit 1.1.1.0/24 count (0 packets)
seq 10 deny 2.1.1.0/24 count (0 packets
Dell#
Dell# show ip accounting access-list L3-ACL vrf vrf3
!
Standard Ingress IP access list L3-ACL on vrf3
Total cam count 3
seq 5 permit 10.1.2.0/24
seq 10 permit 20.1.2.0/24
seq 15 permit 30.1.2.0/24
Dell#
Standard IP ACL Commands
When you create an ACL without any rule and then apply it to an interface, the ACL behavior reflects an implicit permit.
The platform supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types and Common IP ACL Commands sections.
deny
To drop packets with a certain IP address, configure a filter.
Syntax
deny {source | any | host {ip-address}} [no-drop]
To remove this filter, you have two choices:
● Use the no seq sequence-number command if you know the filter’s sequence number.
● Use the no deny {source [mask] | any | host ip-address} command.
Parameters
source Enter the IP address in dotted decimal format of the network from which the
packet was sent.
any Enter the keyword any to specify that all routes are subject to the filter. You can
enter any of the following keywords to specify route types.
● bytes — Enter the keyword count to count packets the filter processes.
● count — Enter the keyword bytesorder to count bytes the filter processes.
● dscp — Enter the keyword dcsp followed by the DCSP value to match to the
IP DCSCP values. The range is from 0 to 63.
● fragments — Enter the keyword fragments to use ACLs to control packet
fragments.
● order — Enter the keyword order to specify the QoS order of priority for
the ACL entry. The range is from 0 to 254 (0 is the highest priority and 254 is
the lowest; lower-order numbers have a higher priority). The default is, if you do
not use the keyword order, the ACLs have the lowest order by default (255).
host ip-address Enter the keyword host and then enter the IP address to specify a host IP address
only.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not configured.
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
174 Access Control Lists (ACL)